The core of daily maintenance is to "promptly eliminate hidden dangers and prevent minor problems from accumulating into failures." The steps are simple but require strict adherence:
Before starting the machine: Confirm that the equipment is in "normal condition" before restarting.
Check the power and air supply: Is the power supply voltage stable? (The fluctuation range must be within ±5% of the rated voltage; otherwise, it may cause malfunctions in the CNC system or spindle motor.) Is the air supply pressure within the specified range (generally 0.4-0.6 MPa. Insufficient pressure can cause pneumatic clamps to loosen the part, leading to machining deviation).
Check cooling and lubrication: Is the coolant tank level above the mark? (If insufficient, promptly refill with the same type of coolant. Do not mix different brands to prevent chemical reactions and precipitation from clogging the lines.) Is the automatic lubrication system functioning properly? (For example, for the guide rail and lead screw lubrication lines, manually trigger lubrication once to observe whether the oil is flowing smoothly. If no oil is present, check for blockages in the oil pump or lines.)
Clean key areas: Use compressed air to blow away grinding debris from the grinding wheel guard (to prevent accumulation and scratching of the part surface by the rotating grinding wheel). Wipe away oil and iron chips from the worktable and guide rails. (Residual iron chips can be pressed into the guide rails during machining, causing scratches and affecting motion accuracy.)
During machining: Observe "abnormal signals" in real time.
Monitor for sound: Normal grinding produces a uniform "grinding" sound. If any unusual noises (such as the grinding wheel hitting the part or high-frequency noise from the spindle) are detected, stop the machine immediately for inspection. These may indicate an unbalanced grinding wheel, loose part clamping, or worn spindle bearings.
Observe the grinding status: If "burn marks" (localized blackening or yellowing) suddenly appear on the part surface, this may indicate insufficient cooling (the nozzle is misaligned with the grinding point) or a dull grinding wheel (needing to be dressed). If dimensional fluctuations are significant (e.g., several parts are consistently out of tolerance), check the feed system for play (e.g., a loose leadscrew nut).





